|  | /* | 
|  | * Fill Window with SSE2-optimized hash shifting | 
|  | * | 
|  | * Copyright (C) 2013 Intel Corporation | 
|  | * Authors: | 
|  | *  Arjan van de Ven    <arjan@linux.intel.com> | 
|  | *  Jim Kukunas         <james.t.kukunas@linux.intel.com> | 
|  | * | 
|  | * For conditions of distribution and use, see copyright notice in zlib.h | 
|  | */ | 
|  |  | 
|  | #include <immintrin.h> | 
|  | #include "deflate.h" | 
|  |  | 
|  | #define UPDATE_HASH(s,h,i) \ | 
|  | {\ | 
|  | if (s->level < 6) { \ | 
|  | h = (3483 * (s->window[i]) +\ | 
|  | 23081* (s->window[i+1]) +\ | 
|  | 6954 * (s->window[i+2]) +\ | 
|  | 20947* (s->window[i+3])) & s->hash_mask;\ | 
|  | } else {\ | 
|  | h = (25881* (s->window[i]) +\ | 
|  | 24674* (s->window[i+1]) +\ | 
|  | 25811* (s->window[i+2])) & s->hash_mask;\ | 
|  | }\ | 
|  | }\ | 
|  |  | 
|  | extern int read_buf OF((z_streamp strm, Bytef *buf, unsigned size)); | 
|  |  | 
|  | void fill_window_sse(deflate_state *s) | 
|  | { | 
|  | const __m128i xmm_wsize = _mm_set1_epi16(s->w_size); | 
|  |  | 
|  | register unsigned n; | 
|  | register Posf *p; | 
|  | unsigned more;    /* Amount of free space at the end of the window. */ | 
|  | uInt wsize = s->w_size; | 
|  |  | 
|  | Assert(s->lookahead < MIN_LOOKAHEAD, "already enough lookahead"); | 
|  |  | 
|  | do { | 
|  | more = (unsigned)(s->window_size -(ulg)s->lookahead -(ulg)s->strstart); | 
|  |  | 
|  | /* Deal with !@#$% 64K limit: */ | 
|  | if (sizeof(int) <= 2) { | 
|  | if (more == 0 && s->strstart == 0 && s->lookahead == 0) { | 
|  | more = wsize; | 
|  |  | 
|  | } else if (more == (unsigned)(-1)) { | 
|  | /* Very unlikely, but possible on 16 bit machine if | 
|  | * strstart == 0 && lookahead == 1 (input done a byte at time) | 
|  | */ | 
|  | more--; | 
|  | } | 
|  | } | 
|  |  | 
|  | /* If the window is almost full and there is insufficient lookahead, | 
|  | * move the upper half to the lower one to make room in the upper half. | 
|  | */ | 
|  | if (s->strstart >= wsize+MAX_DIST(s)) { | 
|  |  | 
|  | zmemcpy(s->window, s->window+wsize, (unsigned)wsize); | 
|  | s->match_start -= wsize; | 
|  | s->strstart    -= wsize; /* we now have strstart >= MAX_DIST */ | 
|  | s->block_start -= (long) wsize; | 
|  |  | 
|  | /* Slide the hash table (could be avoided with 32 bit values | 
|  | at the expense of memory usage). We slide even when level == 0 | 
|  | to keep the hash table consistent if we switch back to level > 0 | 
|  | later. (Using level 0 permanently is not an optimal usage of | 
|  | zlib, so we don't care about this pathological case.) | 
|  | */ | 
|  | n = s->hash_size; | 
|  | p = &s->head[n]; | 
|  | p -= 8; | 
|  | do { | 
|  | __m128i value, result; | 
|  |  | 
|  | value = _mm_loadu_si128((__m128i *)p); | 
|  | result = _mm_subs_epu16(value, xmm_wsize); | 
|  | _mm_storeu_si128((__m128i *)p, result); | 
|  |  | 
|  | p -= 8; | 
|  | n -= 8; | 
|  | } while (n > 0); | 
|  |  | 
|  | n = wsize; | 
|  | #ifndef FASTEST | 
|  | p = &s->prev[n]; | 
|  | p -= 8; | 
|  | do { | 
|  | __m128i value, result; | 
|  |  | 
|  | value = _mm_loadu_si128((__m128i *)p); | 
|  | result = _mm_subs_epu16(value, xmm_wsize); | 
|  | _mm_storeu_si128((__m128i *)p, result); | 
|  |  | 
|  | p -= 8; | 
|  | n -= 8; | 
|  | } while (n > 0); | 
|  | #endif | 
|  | more += wsize; | 
|  | } | 
|  | if (s->strm->avail_in == 0) break; | 
|  |  | 
|  | /* If there was no sliding: | 
|  | *    strstart <= WSIZE+MAX_DIST-1 && lookahead <= MIN_LOOKAHEAD - 1 && | 
|  | *    more == window_size - lookahead - strstart | 
|  | * => more >= window_size - (MIN_LOOKAHEAD-1 + WSIZE + MAX_DIST-1) | 
|  | * => more >= window_size - 2*WSIZE + 2 | 
|  | * In the BIG_MEM or MMAP case (not yet supported), | 
|  | *   window_size == input_size + MIN_LOOKAHEAD  && | 
|  | *   strstart + s->lookahead <= input_size => more >= MIN_LOOKAHEAD. | 
|  | * Otherwise, window_size == 2*WSIZE so more >= 2. | 
|  | * If there was sliding, more >= WSIZE. So in all cases, more >= 2. | 
|  | */ | 
|  | Assert(more >= 2, "more < 2"); | 
|  |  | 
|  | n = read_buf(s->strm, s->window + s->strstart + s->lookahead, more); | 
|  | s->lookahead += n; | 
|  |  | 
|  | /* Initialize the hash value now that we have some input: */ | 
|  | if (s->lookahead >= MIN_MATCH) { | 
|  | uInt str = s->strstart; | 
|  | s->ins_h = s->window[str]; | 
|  | if (str >= 1) | 
|  | UPDATE_HASH(s, s->ins_h, str + 1 - (MIN_MATCH-1)); | 
|  | #if MIN_MATCH != 3 | 
|  | Call UPDATE_HASH() MIN_MATCH-3 more times | 
|  | #endif | 
|  | } | 
|  | /* If the whole input has less than MIN_MATCH bytes, ins_h is garbage, | 
|  | * but this is not important since only literal bytes will be emitted. | 
|  | */ | 
|  |  | 
|  | } while (s->lookahead < MIN_LOOKAHEAD && s->strm->avail_in != 0); | 
|  |  | 
|  | /* If the WIN_INIT bytes after the end of the current data have never been | 
|  | * written, then zero those bytes in order to avoid memory check reports of | 
|  | * the use of uninitialized (or uninitialised as Julian writes) bytes by | 
|  | * the longest match routines.  Update the high water mark for the next | 
|  | * time through here.  WIN_INIT is set to MAX_MATCH since the longest match | 
|  | * routines allow scanning to strstart + MAX_MATCH, ignoring lookahead. | 
|  | */ | 
|  | if (s->high_water < s->window_size) { | 
|  | ulg curr = s->strstart + (ulg)(s->lookahead); | 
|  | ulg init; | 
|  |  | 
|  | if (s->high_water < curr) { | 
|  | /* Previous high water mark below current data -- zero WIN_INIT | 
|  | * bytes or up to end of window, whichever is less. | 
|  | */ | 
|  | init = s->window_size - curr; | 
|  | if (init > WIN_INIT) | 
|  | init = WIN_INIT; | 
|  | zmemzero(s->window + curr, (unsigned)init); | 
|  | s->high_water = curr + init; | 
|  | } | 
|  | else if (s->high_water < (ulg)curr + WIN_INIT) { | 
|  | /* High water mark at or above current data, but below current data | 
|  | * plus WIN_INIT -- zero out to current data plus WIN_INIT, or up | 
|  | * to end of window, whichever is less. | 
|  | */ | 
|  | init = (ulg)curr + WIN_INIT - s->high_water; | 
|  | if (init > s->window_size - s->high_water) | 
|  | init = s->window_size - s->high_water; | 
|  | zmemzero(s->window + s->high_water, (unsigned)init); | 
|  | s->high_water += init; | 
|  | } | 
|  | } | 
|  |  | 
|  | Assert((ulg)s->strstart <= s->window_size - MIN_LOOKAHEAD, | 
|  | "not enough room for search"); | 
|  | } |